Search results

Just install it right with fender washers on both sides and bolts and it won’t go anywhere. Mine is still there after countless 150+ runs.

One of the old web forums I used to own got so bad we basically had to do IP bans on whole countries. lol

You bought a sporty suv with firmer shocks and struts and low profile tires…the ride quality is what’s expected from that package. 20’s may help some but you still have the suspension to deal with…you could swap shocks and struts for Platinum versions to soften it up some more. Check your tire...

18’s with Street Pack brakes. If he has 21’s those are the brakes he has.

That’s a fact. Take a look at that gloss black trim piece on the bottom of the front bumper…if there’s any miles on the car at all it’s sand blasted. I replaced that piece when I installed the lip and had both wrapped in clear PPF.

Mine wasn’t painted…it’s molded gloss black. I can tell you now…double sided tape and/or self tapping screws won’t hold it. I used 1/4” stainless bolts with nylock nuts and 1” fender washers on both sides every 6ish inches.

Not only EQ but also any filters they used in their tuning process. OEM’s love all pass filters and if you don’t know what they did it makes it quite a bit harder to make things sound good.

If you use the NAV it’s a dead flat signal out. We’ve measured it more than once in more than one Ford vehicle. There’s nothing better on the market. With it being a CAN-BUS car even the USB is a great input because it maintains a digital signal all the way through the chain to your processor or...

So you got good advice to go with a 31.5” tall tire but you went with a 33”+ tall tire? I don’t get it but ok…you now know why nobody told you to use a tire that tall…it won’t clear the strut by a large margin.

You could have saved yourself a lot of hassle if you had done some reading or asked about wheel fit first. Your tire is too tall, that’s obvious. Now depending on wheel width and offset plus the tire that’s too big, when you put on the spacer it’s gonna rub the fenders HARD when you try to turn...

He’s looking at an amp with speaker level inputs so he won’t need an interface. It’s far from ideal but it will make sound. It’s no different than wiring in a line level converter like an LC2i.

You can modify your car in CA…tuning can be a pain though. It’s very expensive to get CARB exemptions for tuning but it is possible. Those that can’t or won’t pay for it can’t sell their tunes into the state….but to say you can’t modify your car is a stretch. I drove a blown Ram R/T on meth for...

Not getting a 5Star tune is a good thing. Literally the bottom of the barrel for tuning. Do some research, you’ll see who’s better, then try again but have someone else pay this time.

Emblems made it. Came out exactly how I pictured.

I don’t think a VIN is really needed…just an out of CA address. Unless something has changed? Wont the VIN show up anyway when the oem strategy is pulled whether it’s SCT or HP?

Hypocritical how? I’m not chastising someone for stupid shit while ignoring the fact that I also break the occasional law…daily. Can you say the same?

I’m sure we’re all happy you walk on water. FFS it’s a tune…let the guy enjoy life. If it were a post about CA being too hard on aftermarket stuff you’d be all over it. I’m sure you’ve also never ran a stop sign, red light, never speed and uphold 100% of every law you encounter…or are you just...

Relax…literally everyone in CA that’s tuned does it this way. It’s not like he’s running drugs…

Got it covered in bugs and sand.

Put an impact on it and give it the beans.