Did the Lincoln screen swap

[UNBROKEN]

Here's the problem. The number of saved radio stations was not being saved. After starting the machine, I had to go into the settings and adjust the number of stations.

Any idea why it’s only some cars?

 

[Andron78]

Any idea why it’s only some cars?

I think it's related to the initial settings of the ACM and APIM blocks. In order to display the correct number of tabs, the "Number of presets" and "Mixed mode presets" settings must be consistent. This means that the owners of the Lincoln vehicles with these screens were using a different number of tabs than the machine where the Lincoln monitor was installed. Therefore, this is not a problem but rather a matter of proper configuration.

 

[ConspicuousConsumption]

This means that the owners of the Lincoln vehicles with these screens were using a different number of tabs than the machine where the Lincoln monitor was installed.

this is very interesting. My unit came off a vehicle that was wrecked in initial transport, so I assume there were no saved channels.

 

[UNBROKEN]

this is very interesting. My unit came off a vehicle that was wrecked in initial transport, so I assume there were no saved channels.

Mine was from the same type of source.

 

[Andron78]

this is very interesting. My unit came off a vehicle that was wrecked in initial transport, so I assume there were no saved channels.

I don't think it matters whether you had them or not, but it's important that this setting had different meanings on your car and the broken one. You probably had several stations saved, but the new car didn't have any.

 

[elvenleader3]

Not sure if I should start a new thread, but I went to setup my Aviator screen, the orientation refused to change. I changed the APIM settings to Lincoln and Lincoln MY20 10in, and its still messed up. Its my first time using Forscan, so I'm not sure if I'm just doing something wrong. Thanks in advance

 

[Andron78]

Not sure if I should start a new thread, but I went to setup my Aviator screen, the orientation refused to change. I changed the APIM settings to Lincoln and Lincoln MY20 10in, and its still messed up. Its my first time using Forscan, so I'm not sure if I'm just doing something wrong. Thanks in advance

Lincoln MY20 10in correct setup

 

[Andron78]

Not sure if I should start a new thread, but I went to setup my Aviator screen, the orientation refused to change. I changed the APIM settings to Lincoln and Lincoln MY20 10in, and its still messed up. Its my first time using Forscan, so I'm not sure if I'm just doing something wrong. Thanks in advance

the values need to be changed in two lines

 

[Mikes 22St]

the values need to be changed in two lines

Andron, or anyone else, Can you tell me the right part number for the vents so they r wider for the lincoln screen ?? Do u know the part number ?? I have searched through this and other posts and searched at ford and lasco , Finally went with marority and ordered the LB5Z 99018B40CA and it is exactly whats in my st !! Is it the LB5Z99018B40DA, Anyone know ?? I have the chrome ring on the trim. I also had a number of LB5B19F648BC which I couldnt find .. Thanks