1.25" wheel spacer, stud trimming

[UNBROKEN]

30mm is just the thinnest available spacer that doesn’t require trimming studs. That’s only 1.75mm thinner than a 1.25” spacer but when you’re already pushing the wheel past the fender, every mm counts.

 

[WaferTech]

Conflicting information here on requirements to remove hub or not…. UNBROKEN is the best expert on here, so I am taking what he says as most likely correct, and I will look myself ASAP.

or, maybe I will just use the Eibach 30mm ones, which UNBROKEN says don’t need stud change or modification.

UNBROKEN and others - not sure if I saw your view on this question: 1” vs. 30mm is about .1in difference, 30mm being around 1.1.” I doubt that is a visible difference, but it might be…. I know looks is subjective….. what comments does everyone have on 1” vs. 30mm?

No conflicting information, manual says to remove the hub, If you choose to take a shortcut it's on you.

 

[UNBROKEN]

No conflicting information, manual says to remove the hub, If you choose to take a shortcut it's on you.

I’d bet money no tech on the planet is pulling a hub when one whack with a ball peen will shoot them out the back. Been doing it like that for decades.

 

[ARC]

I went through this debate when doing mine. I just went with the 1.25 in pacers imply because of the ease of installation. With that said yes, it does make a difference on the front as the wheel will stick out just enough to throw mud, tire dressing, etc. on the body sides.