Search results

Very nice. I had the exact same issue with the oem fittings up front. I ran out of time and haven’t had a chance to take another shot at it. I got the oem lines back on up front at least. I’ve been way too involved in the audio build but as soon as that’s done the rear 380 rotors and braided...

Knocked out a bracket to mount the main fuse at lunch today. It will mount using oem bolts next to the battery. Also got the stand off base made for the distro blocks. I need 3 each +/- for the amps but I also need to pull power for the DSP and lighting so I added another block for those and...

That was a small run, all were replaced and there have been no ongoing issues. I’ve had SPD DP’s in for probably a year and 20K+ miles with zero issues.

I forgot the ground. It’s a unibody car so I went straight through the floor pan. Ground the paint off on both sides, star washer under the lug and bolted in tight with a 10mm bolt and nylock nut with fender washers on the bottom side and sealed after with silicone.

Running cables today. Fitting 0ga power and three runs of 12ga speaker wire was a little tight on the passenger side but everything fit inside the OEM channels and under the 3rd row seat to aim at the amp rack.

Just normal plastic snap in grommets. I drilled them with a step bit.

I don’t think many people would be interested when they saw the cost. lol

Oem trim panel drilled and snap grommets in place for the wiring. I’ll add some butyl around the back of those so they don’t make any noise.

Getting closer.

Today’s progress. Put carpet on the top of the enclosure only just to decouple the trim panels a bit. The magnets still hold them just fine. Got the enclosure bolted in using the oem hole for the Jack and spare but it wasn’t solid enough for my liking so I went through the floor pan with another...

the difference is body size and cell count. FenFab uses a smaller 300 cell cat that may or may not need defoulers installed. No big deal for most people. SPD uses a larger 400 cell cat that won’t need anything.

Just take the clips off and lift up the plastic cover. Kind of a pain but not horrible.

I didn’t want polypropylene.

Nah…XS Power takes care of me.

New battery on the way. XS Power D4800. Tomorrow I’ll wrap all the panels and finally have a look at “finished product”. Sunday I start pulling wires.

XS Power D4800 on the way to replace the stock battery. I think the oem 220amp alternator should suffice for now.

I have 2 friends that own car washes like this. Both give high def cameras all over the place with signs saying they file charges for trashing the place. Both have done so and won damages many times. Side note…the one in Michigan has a “regular” who uses the stalls for privacy to handle her own...

I prefer digs…RWD would be useless to me with this thing.

All custom made for that car. I doubt you’ll find them for sale anywhere.

Uhhhh…huh?