Search results

That’s the cold side and fits fine. I’m talking about the hot side piping not fitting…see post #881 above.

Swapped from the TS Kompact Dual Port in the oem spot to the Race Port in the FenFab charge pipe. Simple install with the block off plate and rubber plug for the oem location. I cut the stock plug off and hard wired the resistor then mounted it to the radiator shroud. Cut out and reused the...

Got this stuff in the mail today.

Yea…that’s the ST from Wish. lol

That…and hit 160. lol FWIW I drive in Sport exclusively…it shifts into 10th on my normal drives too.

Mine will hit 10th and run north of 160.

I told ya…those links work very well.

Just to clarify the track width is not wider up front…it’s 66.9” front and rear. The rear has more camber so the rear wheels look like they’re tucked in more. A simple rear camber change to -.5° will make them fit the wheel wells the same as the front.

2 black plastic screws and 2 minutes…never have to worry about it again.

^^ That’s Rich’s car…and the only way racing stripes should be on these things. He nailed it.

Saw a pic on FB the other day…the stitching is horrible. Red on one side and blue on the other…looks like an afterthought.

Finished up my power supply wiring while I’m out of town this week. Complete overkill with Stinger HPM 4 gauge all covered in TechFlex with 1000 amp dual live clamps. Made a short 3’ lead to hit my charging posts under the car with a 7' lead in case I need to extend it to a battery.

Hot side turbo piping from FenFab for a weekend project.

Again…switch it to night mode. It’s better than the white screen day or night.

1…there are jumper cable terminals under the plastic cover that takes .0003 seconds to remove. 2…buy a 2020…we have this. 3…same… 4…same again

Brake pads transfer material to the rotor as a matter of function. It’s how brakes work and is part of the bedding process.

If you can catch it on a datalog that’ll be the best way to figure it out. And Level 10 has been hit or miss lately…

Just switch the display to night for that part. Yours doesn’t have buttons beside the headlight switch to dim the dash?

Saw it but it’ll cost another grand+ to make it black. Plus when you build one there’s options for some of the trim in brushed aluminum to fully match our interiors.