Search results

Final trim panel…waiting for the mesh to flush into the top before I cover it.

1st trim panel complete. The amps will be flipped and all wiring will run straight into the oem trim panel behind them. Virtually no wires will be seen. This panel is held in place with neo magnets. The final trim panel will be press fit where the factory piece goes. I’ll order new Mosconi...

Today’s progress. Glued and screwed enclosure that bolts down inside using the oem spare tire mount. T-nuts for the sub. Amp rack is welded up and everything fits like I wanted.

It’s standard on European ST Line hybrids…which is what that is. I almost had a swap worked out with a guy overseas but he wasn’t positive they would interchange and backed out.

I’ll have that badgeless grille ordered as soon as possible.

I have no way to measure that so I’m not sure.

Total overkill but I like overkill…Stinger HPM 12 gauge for the front stage and HPM 8 gauge for the sub.

Or run some Bora spacers…which IMHO stock wheels need anyway.

We know the bolt pattern is the same…I wanna know how they got the calipers mounted.

It was all over FB and there’s an HP Tuners decal on the rear of the front doors.

You get a track list and load them on your preferred device.

They are not above cutting springs to get something low. I’ve seen it on quite a few of their specialty vehicles before.

They used HP tuners to tuning. That should tell you how serious they are about getting a Ford tune out… In other words they’re not..

I’ve never ran rear fill in a SQ competition vehicle…100% not needed and just adds tuning issues. I went undefeated in MECA Street class in 2013/14 so I’m building off what I learned back then. I had a very similar system then too.

I don’t run rear fill. The goal is a wide, deep front stage so that’s where the money is going. I know I can accomplish that using oem locations but the stage height is the question mark right now. If I can’t get the height I want I already bought a pair of a-pillars to move the mid/tweeter up...

It’ll take me at least a month just to get this done…I don’t think you’d like my turnaround time. lol

Just get both 93 and E50 tunes…takes just a couple minutes to swap tunes.

Hard to find right now…1/2” 10 ply Baltic Birch for the trim panels and 13 ply 3/4” Baltic Birch for the subfloor and enclosure. No corners cut on this install and no MDF anywhere.

Just waiting on a couple of small things but almost all the install supplies are in.

Almost all the install supplies are in…just waiting on a few small things now. Picking up the 13 ply Baltic Birch for the enclosure and trim panels tomorrow. Hoping to have the sub floor and enclosure fabbed this weekend along with the floating amp rack welded up