Recent content by Stinger

Sounds smooth. Is the in cabin drone more pronounced? Sent from my iPhone using Tapatalk

Any exhaust sound clips? I have the stainless MBRP and almost same upgrades as you. Did you install them yourself? Sent from my iPhone using Tapatalk

I ditched the stock Ford flex pipes completely and had stainless braided flex joint installed

Mine is broken also.

I’ve had the Mishimoto for a few months now and really like it. Easy install and high quality. Sent from my iPhone using Tapatalk

The MBRP has drone but gets better with use. Borla is 2.25. I’d go Thermal or custom 3” like Unbroken and others. Sent from my iPhone using Tapatalk

Off topic- I’m really liking my Mishimoto catch can. It’s simple and high quality. The price was reasonable. [emoji1303] Sent from my iPhone using Tapatalk

The drone on my MBRP stainless system got better with time. I really noticed it drone the other day picking up people with lots of luggage at the airport. It was loaded down and at lower rpm there was a lot of drone when on the throttle. I considered adding a resonator like the Borla in place...

Thanks again for the help and informative answer. Much appreciated. Sent from my iPhone using Tapatalk

Obviously IAT. I was thinking a side effect of the increased volume in the IC might bring total pressure down. But that doesn’t make much sense. Maybe milliseconds longer to get to peak boost. Sent from my iPhone using Tapatalk

Excellent answer. Sent from my iPhone using Tapatalk

Reliability. Running higher than stock boost. Did I need one? No. Did I want one. Yes. The noise is not intrusive at all especially on the highway and around town in low boost. Sent from my iPhone using Tapatalk

I was worried a BOV would put me in the Paul Walker Fast n Furious category. It’s not loud around town when driving normal. At lower levels of boost it’s barely noticeable in the cabin. I installed the purple sound tuning insert to give it a lower sound. It has a nice low hiss. Install was...

Thanks Unbroken. It was the boots. I readjusted and tightened the cold side clamp since the Fenfab pipe tapers pretty good. Then I retightened the hot side. Checked the BOV and connections. Tightened the catch can. Noise gone. What do you estimate my max boost should be on e50? Would the...

I have the ultimate performance IC. The fitting was welded on. I was worried about the sensor the most since it’s so hard to get to. But I made sure it was well seated on install since I didn’t have any gasket maker. Thanks. Sent from my iPhone using Tapatalk