Recent content by mwinn

Hello all. Recently installed the Steeda bushing kit. Simple enough install. Results are as promised. I've noticed a very clear "whoop whoop whoop" noise coming from the real. Low speed only. 5-10 mph. Goes away ( or at least I can't hear it) when I go faster. Figuring just picking up...

Glad to see they're still doing that. Like Blue Beast we had a blast in 2020. "Drive it like you stole it"....in someone else's car!! Fun times.

In my case steeda bar set to medium with stock links

Have similar issue. Not real loud but notice it off and on. Sounds like a rubber squeak. I've had the Steedas on for a little more than 3 years. Big fan so this issue is not a big thing for me. Curious about the cause however.

Look for a label on the lower right driver's side door jamb. The later the better. Units built in 2019 had more issues than later ones. The mileage seems low for a 2020, many of us using these as a daily driver have 60k on them or more. Check for catalytic conv replacement both sides. If...

DaveG gave good advice. I've had my 2020 since May 2020. Many of us have dealt with the gremlins over time and for the most part Ford took care of them. Since you are buying from a Ford dealer get the service report. Post the repair items done on the one your looking to buy. We'll weigh in...

Your dealer makes house calls? I'm in the Charlotte area as well. Looking to switch dealers because....well.. my current one SUCKS.

Looks like a canned tune.

Welcome. There is a ton of stuff. Search under Big Brales. Member UNBROKEN has extensive write ups on various options as well. Enjoy the ride

100%

O Was a fan of the Ford ESP, until I needed it. In my case they looked for every reason to NOT fix anything. Front CV boot split. Would not cover because I had aftermarket (Steeda) springs installed. Flex pipes sprung a leak. Dealership had replaces cats under a recall....Twice, said the...

Rocky??!!!

Hey Cdubya did you grease the shafts yourself or have it done. Having to replace one due to boot failure. Thinking of having shop grease the others while they have it in the air. Is it as simple as the video shows? I half assed tried once but the shaft did not slide back easily and I didn't...

I've tried to use pretty much the same words every way I can and the message comes out the same, even adding punctuation doesn't help.