What Have You Done To Your Explorer ST Today

[Suprawill1]

Yes but my understanding is that the factory pump can’t adequately feed the motor on full E85… E50/E60 is as much as the stock pump can handle.

Yes, that's what I thought.
Now, the HPFP + injectors allow enough fuel for that type of HP but if you're in normal mode, everyday driving, are you getting stock gas mileage or is the modified fuel consumption across the board?

 

[-REDRUM-]

Some paint correction, clay bar and compounded the ST today... tomorrow will be light swirl removal and sealer...

 

[Mattsr70]

Was in the big town today.
Stopped by the tinting shop I always use, just to make an appointment to tint both front side windows to match the rest ones.

He said , bring it on in.
So $100 later and 1 1/2 hrs.
They match.
View attachment 4366
View attachment 4367 View attachment 4364 View attachment 4363

Getting there little by little.....slowly.

Jim

What was the tint percentage

 

[Loaded05]

I installed my CVF intercooler.

 

[Suprawill1]

I installed my CVF intercooler.


View attachment 21826

Good job!

 

[-REDRUM-]

finished my weekend project...

 

[Flyman]

Some paint correction, clay bar and compounded the ST today... tomorrow will be light swirl removal and sealer...

May i please ask how did the Wolfgang perform? I've used Adam's, wasn't thrilled with outcome.

 

[-REDRUM-]

I have been using only Wolfgang products for about 10 years… tried some others and never got the affect I wanted. I start with Uber Compound, then go to the Total Swirl Remover, then Paintwork Polish Enhancer, and finally the Deep Gloss Paint Sealant.

 

[Flyman]

Very nice. Thank you for the reply. I am going to give them a shot.

 

[-REDRUM-]

You bet! The compound and swirl remover should be applied by buffer… the polish enhancer can be applied by hand. It should be applied in a straight line, not in a circular pattern. Sealer can be applied by hand in any manner. Good luck, hope you get the results you are looking for!

 

[V3nom3nom]

Installed CVF Cold side Charge pipe and drained catch can.

 

[Autoworker]

New Goodyear MaxLife 255/55-20 tires and all wheel alignment. 48;000 miles on the factory Michelins. $1070.00 out the door.

 

[MacandCheeseST]

Ordered CR P Stage 5 turbos - Nostrum Stage 3 injectors - as well as xdi evo fuel pump - next stop drive line and tranny - see ya @ the finish line...

 

[MacandCheeseST]

ordered the V2 FENFAB air intake.. LOVE the single filter - it SOUNDS NASTY.. The 2 filter and more airflow is gonna help these stage 5's BREATH!!!

 

[WaferTech]

AWE 3" Exhaust just arrived, box was beat up, but the lollipop and all other parts were intact. I was worried about the tips, but they were packed in a separate foam inserted box.

 

[Suprawill1]

Ordered CR P Stage 5 turbos - Nostrum Stage 3 injectors - as well as xdi evo fuel pump - next stop drive line and tranny - see ya @ the finish line...

Daggone, ya tryna make the chassis leave the body behind? What kind of power are you aiming for?

 

[MacandCheeseST]

Daggone, ya tryna make the chassis leave the body behind? What kind of power are you aiming for?

I’d like to go north of 650 the tires… it’s gonna be close - trying to get in the high 10”s - I’ve seen other guys with stage 1 injectors on the pure turbo 650 make mid 600.. with similar set up - I’m just running the CRP and stage 3…

 

[Suprawill1]

I’d like to go north of 650 the tires… it’s gonna be close - trying to get in the high 10”s - I’ve seen other guys with stage 1 injectors on the pure turbo 650 make mid 600.. with similar set up - I’m just running the CRP and stage 3…

So, you're using ethanol then.

 

[MacandCheeseST]

So, you're using ethanol then.

Absolutely

 

[st8]

Added color matched explorer lettering