Search results

Just figured i would post this as an FYI My wife said that the car is rough starting after filling up with gas. Also a check engine light came on for a P0456. I thought maybe the capless fuel filler and cleaned that and sprayed a bit of silicon on the emergency filler tube then proceeded to...

Cdubya, good luck with the updates. I can say that my camera hasnt blue screened since i put in the newer one even before the IPMB updates. For me the hits keep coming. Now i have a P0456 error. Very small evap leak detected. Wife said it was rough starting after a fill up. Been reading...

Thanks Cdubya! I have been fighting this for a year. I first swapped the half shaft speed sensor, i actually did it twice thinking maybe i got a bad sensor. Then i pulled the drivers seat and started tracing wires. Found a open ground, which if i recall goes to the sheath of the harness. It...

All done. All the updates completed. Cleared all the DTCs, there were a ton. All related to communication errors to modules. I am guessing that they are due to the firmware loads. Started it up, not one DTC. Took it for a short test drive and no issues, no noises, nothing. Driving fine...

Not sure what happened but i am in. And updating the PCM right now. Looks like it may be a long night of updates Wish me luck!

I just tried my desktop wich is overkill for this app. Same thing.

Thanks. I can get it to show passed for all. If i click on dealer it takes me to the motorcraft login. If i select independ/non dealer it goes nowhere and comes back with no connection. I am logged into motorcraftservices site. From there i can login to the other site where i purchased my 2 day...

Alright guys this drama never ends here. Bought a 2 day license and i cannot get FDRS to login. Attached a pic of the issue. Are these servers down?

I used a block of wood on top of the jack. Slid that underneath the bellhousing. Wasnt perfect but it worked. I could only pump the jack like a mm at a time. Took some time. The book says to remove the entire block and put it aside. I could not figure out to get that block out of there. I had...

Update for you guys. Started at about 645 tonight just got done with most of it. Getting that damn shaft out sucked. But its out and new one is in and torqued. The only bolt not torqued is the axle nut that goes to 266ftlbs. I got it to 150 (max of my wrench). The next issue is that the vent...

That makes way more sense. I was like how the hell do i get these to connect. Cheers

Thanks you for the info. I am waiting on my mongoose cable and a day to do this. I also just noticed that they sent me a rev E axle not the F. That must be why i am confused. Since they both have splined shafts. The new F rev must be the new design to fit with this intermediate shaft. Looks...

Whats up folks? Wondering if anyone has information on this new intermediate shaft/ actuator assembly. I am having the C0631:14 and C0632:85 show up on forscan. With a ton of errors on the dash. I found a TSB that listed a bunch of parts for this. I found the oil dripping out of the...