Search results

I'd say for my daily driven stocker, i'm leaning towards the ID Speed brace just for the EPDM bushing and lessened likelihood of NVH.

If it makes a difference to anyone here, I’d argue that not having the washer setup cost me a camera due to having to wipe the salt off it all winter. See this thread for camera replacement info Rear Camera Replacement | Explorer ST Forum .

And these were the clips I broke. I did take this trim panel off 2-3 times for the camera washer install, so i'm sure that was the cause of them breaking now. The 10mm bolts do a good job holding the panel on, but i'd like to grab some new clips to make it a tighter fit. The parts diagrams...

Ok, after searching and finding some info on other vehicles, I found the method that worked. Actual camera swap is pretty easy. The darn clips in the rear trim are fragile so go easy. I still broke a few so if anyone knows the part number for replacement clips, i would appreciate that. Back...

Here's an obscure question. My ST is a Canadian-spec car, that was imported into the US. SO it has a few unique things about it. Someone mentioned that the US cars have a DRL menu in the settings that allows for disabling of the DRL's while driving? As we all know, Canadian cars all have...

On my '23 it's in the ACM Disabled "Engine Sound Enhancement" and "Software Engine Sound Enhancement". Threw it in Sport mode and that seemed to have done the trick. Separately, I also turned on Software Anti-Noise Control and the three ANC microphones. WIll give this a try and see what...

Digging it into this more, i have discovered that you can make the seating config change through ForScan to prevent the seatbelt warning from going off. (At least for '20-24) It's in the IPC. It's a drop down menu built into ForScan already so no need to look up lines of code. In the IPC...

EDIT: Solved. read 2nd post I want to replace my rear camera. My overzealous self wiped it one too many times this winter with salt coating the lens and scratched it up. I actually ended up adding the rear camera spray line to my car to avoid this issue in the future. I have the camera and...

Rockauto has the rear ST-specific motorcraft shocks for $112 each. They are actually pretty easy to DIY if oyu can safely remove the rear wheels

You are likely only reading ECU codes with that programmer. It won’t scan the other modules for DTCs, as that’s where the error is likely stored. If i had to guess it's probably in the BCM module. Really need to scan with ForScan or a higher end scan tool that can read all module DTCs

Well, ended up not being a big deal. Carefully estimated where it should be based on above pic and drilled a 1/2" hole. I then used a stepper bit to ream the hole slightly larger and oval it out left and right. Only took a few seconds to do so go slow and check fit often. But grommet went...

Finally got around to installing mine. Ran into a bit of a snag. mine is a late ‘23 and seems to not have the hole/grommet that is specific for the washer fluid line to pass through. I was scratching my head for a few mins wondering how the fluid got through before I realized it’s just not...

I was in for a different warranty issue (HVAC blower motor bearing squealing) and they just proactively inspected the seal on my '23 because they said "Pretty much every explorer coming in now has this seal leaking" Prob a good idea for folks to get under their vehicles and inspect theirs if...

Cant say mine has ever done that. Even paid extra attention to it on the drive home and no vibrations, nor can i ever recall it every vibrating before. Running or while off.

I've got 2 on 87 and 2 on premium. My wife has a '24 CRV. Boring to drive but runs on 87 and gets almost 40 MPG. Been using that lately when I need to make a drive. ST is sitting at 19 MPG. My right foot might be to blame for that. ;) $4.60 for a fill up today. :(

Damn I paid $4.50 for 91 octane 2 days ago. Hate to see what it is now but I'm at 3/4 tank. I usually fil around 1/2 tank

I still see it pop up on the FB groups. Usually a quick reset of the system (hold power and right seek) gets it back to normal.

Looks like it affects pretty much all pre-facelift models: Just checked my app and don't see it listed there for me. I've never personally had this issue (although i've seen folks on FB groups post pics of it) , so I'll probably sit back and let others go first as I have the full-screen mod...

This is who makes the seat insert material. It's a type of suede Home - Dinamicamiko

Indifferent to the feature. I don't mind it. Lots of folks don't realize if you go from Park to Drive and just hit the gas, it automatically releases. Only time this isn't ideal is when you need to creep forward (like out of a parking space) and don't want to hit the gas. But you get used...