Search results

Not really today, more of a Friday. Yesterday was a re-tune by Jeffrey Hald with TotalTuningUSA. Installed my new sub enclosure built by MTI, installed my new pillars built by me. (wrapped by Tam out of Houston) I still need to hook up the LED for the enclosure.

Take it off and apply some CCF to the back side of the panel. Get some cloth tape and apply a layer where any pins are. Pay particular attention to where the rattle is emanating. It will no longer rattle once it's treated.

Anyone know what channel the collision and impact tones come out of? I no longer have the factory system and need to program the Mobridge. If anyone knows, it will save me some time of bouncing through the channels trying to figure it out.

Wasn't sure how they would look, I didn't want to copy everyone else and I hadn't seen anyone with these yet. I absolutely love them, waaaaaaay better than factory 21s.

I don't post much here, all of my upgrades have been to the sound system until now. So my first non-audio upgrade. The ST got new shoes today. Vossen HF3 22x10.5 wrapped in Toyo Proxie ST III 305x40. Completely change the look of the ST.

Thanks, just wanted to double check. I'm tuning a system and have a nasty null at 81Hz, I wanted to make sure that wasn't it.

Anyone know if the 2022 ST has ANC?

Just thought I would add to this. I figured out why on some occasions, the USB would be active as soon as I started the vehicle. Turns out, if you unlock the vehicle with the keyfob before you head out, it seems to get all the modules fired up and USB will be active and you won't have to switch...

Really. As soon as I start moving, the browse option greys out. If I use the arrow to back out, it will take me to the option page (or whatever the main page is called), but won't let me select anything. If I do, it tells me I can't because I'm driving. If someone is in the passenger seat, it...

Kinda pricey, but might be worth it.

Sometimes, but when I say play so and so, it just shows the albums. I think it complains when you click on it, but it goes through. If I recall correctly. Most of the time, I don't know what I want to listen to and I forget what's on the drive as I change it all the time.

Can the radio nanny be turned off with Forescan? You know the one that won't let you browse a thumb drive if the vehicle is moving.

Rack is removable. 10mm and 2 6mm, remove a couple velcro pieces and I can lift it out. Center support.

Installed my Amp rack finally.

It's most likely a module initialization timing problem like someone previously posted. I wonder if Sync4 has the same problem?

This is very annoying. What I have seen is it tries to load USB, but it's not ready and switches back to XM. Sometimes I have noticed if I remote start the vehicle, it will stay on USB

Got the wire run in the rear doors. Drilling was too much of a hammer and tried to crack the molex connector. So I switched to using flush cutters and a hot exacto knife.

Front is different, it has a wide open spot like you said.

Looking at this back door, I don't see how it can be done without modification. There are plenty of open pins, I'll just drill the unused large pin on the Grey molex. I only need to open it a little bit.

Did you have to drill the connector or did you just push the connector through? I've only briefly looked at it, I haven't messed with it yet, so I am unsure how it's secured or put together.