Search results

and parts are kinda pricey. like around 350-400

just about all the mainstream intercoolers are going to perform the same no matter who made it. the steeda one looks like a rebranded whipple

and, honestly, you pay a yearly fee to opt out of smogging for 8 years from the manufacture date, so it isnt something im very worried about at this point. I went full ZFG but got a weak ass transmission so I cant put it through a real good launch :rolleyes:

why not look at something like this?

i believe someone did a DIY on the rear foot sensor.

any problems pulling the plastics off the hatch? last time I tried to do that with my last explorer I ended up tearing a post on the panel cause it wouldnt come off.

hows the process of taking off the whiper?

ill be there in June myself

type this into your browser. site:explorerst.org intercooler rivets works for just about any website just replace explorerst.org to something different

this reminds me...I need to add this on my ST. So i ran one of these tapped off of my rear cargo light on my Gen 5 explorer and it was plenty of light. I ran it to the top center edge of the cargo area and used hot glue to keep it in place. it never fell off...

Who in Sacramento would be in to have a Mini Meet this Sunday at like Noonish?

BUMP. ill throw in a sensor for $25 more

I personally didnt place my line on the 2 heater lines and suspended it from a bracket I made and attached it to the post hole that is circled below.

yeah all the good stuff was omited for mine...except for the ASS. like why couldnt I get lucky enough to have it missing as all the other goodies.

agree with you there, definite potential to break as you stated and much better idea to run a better offset wheel to compensate. BMW seems to do that well with their wheel placement to the the fender.

yeah I hear ya, but lets me real here - most "high end" tools and products are made in the very same factory as the cheaper alternatives (i.e. The same company that makes Milwaukee tools makes Walmarts Hart line). People like yourself feel spending a lot of money on something means quality, and...

a lot of trim pieces like this will come with their own replacement clips. this was the case in my girlfriends car when someone hit her rear quarter panel.

you never know...they said they were going to omit massaging seats, the foot activated lift gate and the auto stop start on mine. I have everything omitted except the ASS :cautious:. Like i was looking forward to not have that function...

Eh. I think for me my time is worh more than taking it in for an alignment as well as the cost of the actual alignment - at least here in california. Also, I didnt got with the typical bora spacer that everyone seems to get here for around $150 for the pair and got my rear Hubcentric spacers for...

spacer in the rear fit me just fine here. having a bit of the push out in the back accomplished the look i was after without the extra cost.