Recent content by mcfarlrm

Just thought of this as well. Did they check your brakes to make sure they weren't sticking? A stuck piston in the caliper will cause a pull. Especially noticeable when applying the brakes.

M Mine was due to improper steering linkage reassembly when my transfer case was replaced. It did not cause a pull per say but my steering wheel was not dead center when traveling straight down the road. When positioning my steering wheel centered, it listed to one side. Worn or defective...

Most techs I've dealt with regarding my pull didn't think outside the box. They always resorted to an alignment, which didn't fix the issue even though the alignment came back within spec. I insisted that they needed to check my steering linkage and suspension components. Lo and behold, after...

Had my passenger side replaced twice now. First time at 40k miles and second at 50k miles.

Steering linkage would most likely cause your steering wheel not be dead center when cruising straight down the road. Forcing it dead center would cause a pull to one side. Pull due to suspension components, especially if you let your hands off the wheel or feel the vehicle forced in one...

Pure speculation here but it almost sounds like improper suspension/steering linkage reassembly. You would think that after all of that work the least they could do is take it for a test drive. Had the same issue with mine pulling to the right after the transfer case was replaced. Ended up being...

I do but shipping to Hawaii would must likely bankrupt you lol.

Do you have white smoke coming from your exhaust? Did they do a combustion leak test?

Just dropped mine off for this issue. Also, I noticed either diff fluid or oil on my trans pan. Any ideas as to how it ended up there?

Just to confirm, the redesign is MB5Z-7862187-EC correct?

Correction, BMS

Do a BCM reset.

68 Barracuda