Search results

1.25" all around is a good choice. Plenty have done so. A little bit of wheel poke in front, but that's OK. If you want the rears to then match the front, you could do 1.25" front, 1.5" rear. This is what I have and is also what plenty of people have done. They stick out a little with OEM...

Disagree. Those are top-of-the-line trims as well and should get max power. The ST is still the ST in looks, and suspension changes. honestly, with the advent of the lame 3 bolt subframe starting MY2021, I doubt Ford Performance is going to come out with a tune for an ST that is going to...

Did you pull codes with Forscan or just a generic OBD2?

No check engine lights or warnings? Did you try pulling codes?

Eye candy? It looks like a robot is hiding in your engine bay!:LOL:

Did they change the throttle sensitivity more than Sport Mode already does?

After driving a few days, I'm going to have to say this is a winning product for a lot of people. Straight forward install--aside from cutting the stock exhaust. Decent quality materials. Pleasing low tones, a little louder than stock. Looks great--just what I wanted. Priced relatively...

Looks like a cut rather than some defect. I would think you would have noticed that if it came like that when you took possession. Potentially anything hard and sharp can do damage like that. Coat buttons, zippers. Purse hardware. Anything. Sucks. You might try leather/vinyl repair like...

Captured about 10-12 ft away, revs at the end

No T-shirt, no video! lol. Not sure my phone would take good video/sound of that or even the best way to do it.

Not very loud. i noticed it around 2k rpm going 70mph in 9th gear and 50mph in 7th gear. This is with no music playing. you do not have to increase the music volume to overcome the drone, lol. Edit: likely due to failed flex section

Yeah, that MRT H-pipe with the Gibson may as well be a complete aftermarket exhaust. Curious what the result will be. So I had to redo my tip install. They really need to be installed on the parallel portions of the outlet tubes or they will be cockeyed. No one will probably notice but you...

Did you turn the accubass completely off? We don't need it as the stock system does not roll the bass off. If accubass is set too high, it could result in clipping. Are you saying it clips even at lower volumes or just when you turn it up?

Without some way to test out your level convertor, I'd have to say start there. Which lci do you have?

Sound is deeper and a little louder--most noticeable when cold starting the car. It is pretty mellow overall which is what I wanted. The sound is not loud enough to cause problems with the neighbors. On the highway, there is some drone when cruising and giving slight throttle to maintain...

By "invoice" you mean dealer's invoice not MSRP? If so, wow!

Interesting you got a T-shirt!! Installed the axle back this morning. Took longer than I thought, mainly just making adjustments to the alignment--I would recommend some silicone spray on the pipe overlap to make it easier. Be prepared to fiddle trying to get the double outlets level, the...

Great story! Congrats!

Sometimes you just have to wait for a new version to cover the newer cars. What adapter are you using?

Re: ground. In the driver's side footwell, underneath fusebox, there is already a grounding bolt on the side wall. Access is limited so you just want to loosen it enough to fit a spade terminal in there. It's right behind the big wire loom. In the pics below, the black wire with yellow...