Recent content by moto727

Wasn’t for me. I did the same thing, ordered cv fab based on the stated leed time on there website, when they missed the mark, emailed them and they said a month out so I emailed fen fab, he said they would ship in a week and he was wrong, the shipped in 3 days!

You’re probably around e 35. Usually it takes me about 5 gallons of the corn to hit that. Also, here the calculator that I use. https://www.tuneplusinc.com/pages/tuning-tools

It was due to a cheap fuse that i used that was included with the connector. Lesson learned, dont use cheap fuses.

Its a 2025 with 3k miles. i doubt all those sensors died at once.

FBO

I wrapped up the install of the Fuel It Ethanol Sensor, ran to the gas station, filled it with E35 and flashed a new tune on it. I drove for about 15 minutes until i got the ethanol gauge to stabilize at 34% ethanol. I did two pulls for logs went home and shut the car off while i waited for...

Looking for pictures of how you guys wired up the Fuel It ethanol adapter. Ive got the wires run into the engine bay fuse box and havent decided how to power it.

No codes during any part of the tuning process

if you are tuned on 93, is there any benefit to running a few gallons of e85 mixed in?

Are you planning on tuning it? Does anyone support a tune yet for the 2026’s?

Goose

Had a local shop install FenFab downpipes and CV Fab intercooler with the hot and cold side pipes. They dynoed before and after, surprisingly, i picked up 40hp.

If you want to hear the turbos, FenFab is your best option. If you are concerned about the wait, email them. I asked how long it would take to get his downpipes, he said 1-1.5 weeks and got the shipping notice 3 days after i ordered.

What do you need to e85 on a fbo ST?

I checked the transmission fluid and burned my arm in the process. Someone needs to make a dipstick kit. It was slight low, added 1/4 of a quart.