Recent content by M3dragon

OK, so I unplugged the battery for 60 min then re-connected. The issue still happens. My programmer shows no codes.

will give the battery pull a try and report back.

I don't know if it is the camera. Why am I asking if anyone has any ideas to try based on what happened? This is also linked to cruise control, so with this erro,r there is no cruise control.

Yes tried that and still get the message. The only thing I can think is when the radar detector fell, it shorted the camera or did something to un-calibrate it. Based on what I read, it can happen when windshields are replaced. Trying to avoid the dealership if I can fix it on my own.

It's not a visibility issue. The issue pops up as soon as I start the car.

Hello All, Not sure where to start for this error message. "Pre-Collision Assist not available." Context: I had a V1 plug-in using one of those push-pin taps for power, inserted into the back of the camera plug rather than tapping directly into the wiring. The suction cups for the V1 failed...

SOOOooo did AFE show the worst performance? How to all these compare to drop in filter for flow rate?

Nice 2 of us in Lincoln.

subbed to learn more

I run it in CALI no issues on a 21

anyone with a flow bench to test this one vs AFE?

Interesting the long tube is 2 parts.

got his link from UPR tech support for the driver side. Short version is what is used. Ford F150 and Mustang Clean Side Separator CSS - Electronic ECSS Plug N Play ™ (uprproducts.com)

unless someone knows better than I, it would be a whole new flash as I understand it.