Recent content by dragon434

So I recently changed my whole brake setup this past weekend with new rotors and pads The rotors I used were from brake performance and I tried to follow the break in instructions as best as I could with nyc traffic Im not sure if the brakes are bed in properly cause im getting alot of...

So I did the upgrade to the red performance calipers and brake pads with some appropriate drilled and slotted rotors, I couldnt find the “service bleed” option in forscan Maybe its not in forscan lite? also I couldnt do the fun method unbroken suggested because I gotta break in these rotors...

I just had a great battle with cvfab intercooler upgrade. No help. Got it done in 6 hours. Everything was sort of what I expected except for the rivets I had to drill out on the bottom. For the guys that had to drill the 4 rivets is it ok to leave it that like?

how did u guys bleed the ABS system?

when changing the o2 sensors out do u have to use any kinda of thread paste or anything?

im curious on the water part too, anyone have any updates on this? tried searching if it has a water channel or anything but couldnt find.

hey I heard some horror stories about the cerakote ruining the plastic trim after a while, how did it work out for you?

just to piggy back on this a little instead of starting a new thread; lets say I get the DMS tune and i do the Stock+, Tow, Daily, Performance, Race all set to a drive mode does that mean all the original profiles will be erased? like lets say I need to use the ice/slippery mode but its set...

These are the black chrome infact, gotta give it a wash tomorrow. It kinda rapidly deteriorated the past few months. I did do alot of driving this winter, might be from all the salt that was sprayed on the road. this is when I first installed them

They are about 3 years. Im contemplating standblasting it out and spraying them with cerakote or something. Not sure how well it will hold up though

Anyone have an advice for touching up the tips on the borla exhaust. I’ll post a pic to show exactly where the paint is coming off.

Oo damn how did I not see that, I ended up ordering the cvf

do we have to remove the shudders for ic install? Or is it optional with some ic’s?

New or used in or around nyc

Didnt catch the part about the motor improvements, what did they improve? Or was it not the 3.0 engines