Recent content by BigSarge

DaHuntah ... did you get it to work?

I went ahead and followed BrooseDaMoose's advice ... replaced the bad ones with new smoked ones, and siliconed around the seal. Hope this works this time.

Use a 90-degree needle nose pilers on the end with the two tabs to squeeze ... work it out slowly from the back, it will budge Use the trim tool from the front on the other end and just pry slowly ... it will pop out (at least mine did) without breaking.

Here's a close-up for you of the back of the OEM reflector. Just apply pressure up and out at the same time. I didn't snap either one ... in fact, on both sides I popped one end up and used a trim remover tool to slowly pull and the other end popped out.

I wanted to weigh in on this ... I bought my ST in December 2024, bought these lights in January 2025 and installed them in March 2025... it is now July 2025, only 4 months later after install, and the driver's side has a seal issue with condensation inside and is now fading out. So my...

Yes I still have them for sale

Wow ... they look even better all polished up! :)

Traded!

Semper Fi, dog. USMC 1987-1994 US Army 1994-2018

My ST (build date 3/27/2024) is missing this, and the parts website says this does not match my vehicle. But I can buy it and put it on?

PENDING TRADE

Sent you a PM.

Go to another body shop if you have to. I used to own a Wrangler which are famous for "unseen" frame damage that can only be seen once the body shop starts to put it up on a lift, take the bumper off, etc.

I guess I'll have to either get a set already done or do a set myself

I'm looking for 20" OEMs in gloss black ... thank you, though